Categories
Sampling Valves
figure 187 00
• to sample drinking water and determine microbiological parameters according to the German TrinkwV drinking-water regulation
• wetted metal parts made from dezincification-free and corrosion-resistant gunmetal, resistant against aggressive water
• sampling pipe can be disinfected by flame
• can be attached to all Kemper valves with test/drain-port
gunmetal sampling valve
figure 087 00
• to sample drinking water and determine microbiological parameters according to the German TrinkwV drinking-water regulation
• wetted parts made of stainless steel
• sampling pipe can be disinfected by flame
• can be attached to all Kemper valves with test/drain-port
SST sampling valve
figure 188 00
• to sample drinking water and determine microbiological parameters according to the German TrinkwV drinking-water regulation
• sampling pipe can be disinfected by flame
• inlet 10 x 1.25 pipe, outlet G3/8 male thread with compression nut for 10mm pipe
• made of brass, nickel plated
sampling valve for connection to angle stop valve
figure 188 01
• to sample drinking water and determine microbiological parameters according to the German TrinkwV drinking-water regulation
• sampling pipe can be disinfected by flame
• inlet 10 x 1.25 pipe, outlet G3/8 male thread with compression nut for 10mm pipe
sampling valve with CV for connection to angle stop valve
- Stop Valves ꁕ
- Safety Valves ꁕ
- Pressure Reducing Valves and Filter
- Balancing valves ꁕ
- Measuring Products
- Hygiene System KHS ꁕ
- Thermal separators
- Flush-mounted valves
- Stop valves water meter combinations ꁕ
- Frost-proof outdoor taps
- TRESOR Cabinets ꁕ
- Sampling Valves
- ThermoSystem KTS ꁕ
- Other Valves
- Accessories ꁕ
-
Spare parts
ꁕ
- Spare parts for stop valves
- Spare parts for protection and safety valves
- Spare parts for pressure reducing valves and filters
- Spare parts for balancing valves
- Spare parts for measuring products
- Spare parts for sampling valves
- Spare parts for flush-mounted valves
- Spare parts for stop valve water meter models
- Spare parts for frost-proof outdoor taps
- Spare parts for TRESOR cabinets
- Spare parts for hygiene system KHS
- Spare parts for dirt traps
- Handwheels and gaskets
Drinking water quality monitoring - suitable solutions for every installation situation
Existing standards and regulations must be fulfilled - this is the basic prerequisite for a sampling valve. Plumbers, samplers and operators also have additional requirements which must be met. The availability of versions for all areas of application and a cost-saving, variable installation are just as important as the option to use alternative disinfection methods and the ability to take samples easily. In addition, dripping sampling points - even after repeated flaming - or unauthorised removal of water (water theft) are not acceptable.
Sampling valves
About Us
Solutions
