FK-5 break tank station

Product Features

• for the protection of drinking water against non-potable water of fluid category 5 in accordance with DIN EN 1717/DIN 1988-100
• wetted parts on the drinking water side made of gunmetal, stainless steel and drinking water approved plastics
• cover made of EPP
• easy operation using touch screen
• operating times can be defined
• flushing of the PWC line and cleaning of the container (optionally) possible
• readout of data, for example operating status and consumption figures, possible using USB interface
• high performance (flow rate and total head)
• for wall mounting or installation on optional rack
• rainwater utilisation can be integrated (optional)
• control of external immersion and metering pump possible
• low-noise operation
• normally closed inlet valve
• with coupling nut for flat sealing connection thread including EPDM gasket
• plastic drain connection according EN 1717
• frost protection monitor
• drain overflow monitoring (optional)
• BMS fault signal possible through a dry contact
• Connection to power supply with type F safety plug
• Connection to the pipe by enclosed flex pipe (500mm)
• discharge can be increased with a cascade setup (maximum three plants)
• maintenance requirements in accordance with DIN EN 806-5 must be complied
• aditional country-specific versions on request
• for further information on cascading, please contact your sales representative

Standards and Approvals

• DVGW approval
• KIWA approval
• plastic parts with KTW and W 270 approval
• according to accepted materials list from German environmental agency
• device cover building material class B2 in accordance with DIN 4102
• CE marking

Technical data

• pressure rating PN 10
• max. operating temperature 35°C
• min. ambient temperature 2°C
• max. ambient temperature 40°C
• protection class IP54
• power supply 230V AC
• volume of receiver tank 30 l
• Flushing volume of PWC line 10 l/min (at 3 bar)
• electrical power consumption DN 20 3.3 A/DN 25 5.5 A
• power factor 0.97