figure 598 02 065

• incl. brass clamping ring, suitable for all sizes (the plastic clamping ring required to adjust the shaft diameter out of the final assembly set to be used)

• suitable for UP valves Production until 1997

Extension for valves, for assembly set with operating cover, up to 65mm

figure B5105 500 00 002

• with 7mm female square drive, for operation of the square spindle after removal of the final installation set, suitable for all sizes

• suitable for UP valves Production until 1997

socket wrench for flush-mounted valves, for final installation set operating grip

figure B5120 500 00

• for dismantling and replacing inner top parts of frost-proof outdoor valves, Figures 570-572, and inner top parts of the UP and UP-PLUS series, external hex SW17, UP-PLUS series gunmetal, external hex SW18, stainless steel UP-PLUS and UP series, frost-proof outdoor valves Figures 570-572

tubular box spanner, size 17/18, 550mm

figure B5120 599 00

• for dismantling and replacing inner top parts of the ETA-THERM floor balancing valves, internal hex SW19

hexagon socket key, size 19

figure E0109 560 01

• to isolate, regulate and pre-set

• with stainless steel cone

• EPDM-seat gasket

• incl. plastic operating spindle that can be cut to length

• wetted metal parts made from dezincification-free and corrosion-resistant gunmetal, resistant against aggressive water

UP-PLUS inner top part

figure E0109 561 00

• EPDM-seat gasket

• incl. plastic operating spindle that can be cut to length

• wetted metal parts made from dezincification-free and corrosion-resistant gunmetal, resistant against aggressive water

• check valve with SST spring

combined stop-and check valve inner top part for gunmetal flush-mounted valves UP-PLUS

figure E0109 580 00

• complete with valve cone and cone seal

• suitable for UP valves Production until 1997

inner top part for flush-mounted valves (from 1985 to 1997) with shaft length to 80mm

figure E0109 582 00

• complete with valve cone and cone seal

• suitable for UP valves Production until 1997

• 110 mm, shortenable to any length

inner top part for flush-mounted valves (from 1985 to 1997) with shaft length to 180mm

figure E0120 056 00

• to isolate, regulate and pre-set

• EPDM-seat gasket

• incl. plastic operating spindle that can be cut to length

• wetted parts made of stainless steel

stainless steel UP-PLUS inner top part

figure L0100 560 00

• glass fibre-reinforced, continuous external thread, one-way socket for screwing onto flush-mounted valve housing and flush-mounted shafts, 90 mm, shortenable to any length

plastic shaft for UP-PLUS flush-mounted valves and UP-PLUS extension set

figure P0100 560 00

• 90 mm, can be cut to lenght

• made of plastic

• external toothing and internal toothing for connection to the valve bonnet

control spindle for flush-mounted valves UP-PLUS

figure P0100 562 00

•90mm, can be cut to lenght

• made of plastic

• external multi toothing and one-way slide-on socket for connection to control spindle of the inner top part

UP-PLUS extension spindle